Modbus ETNG Configuration

See the Common Device Configuration guide for assistance configuring the General, Options, Details, and Logging tabs. See the Connection/Schedule page for assistance with the Connection tab.

Device Tab

See the Common Modbus Device Tab page.

Time Sync Tab

See the Common Modbus Time Sync page.

Archive Collection Tab

Collection Priority

Low (Default).Queues up with other Low priority items.
Medium. Interrupts Low priority items, and queues up with other Medium priority items.
High. Interrupts Medium and Low priority items, and queues up with other High priority items.

Collection Intervals

Select the desired Intervals relating to the Schedule object assigned on the Connection tab. Each collection will occur at a frequency based on the configuration on the interval.

Select Collect Events if required.

Event Access

Click to select or create a Archive Access. See the Archive Access section for more details.

Event Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

Meter Runs Tab

First Daily Archive Address

Default = 713.

First Hourly Archive

Default = 701.

Meter Run Settings 1-12

Meter

Click to select or create the Meter Object assigned to selected meter run number. See the Meter section for more details.

Select Collect Meter 1 Daily if required.

Daily Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

Select Collect Meter 1 Hourly if required.

Hourly Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

Chromatographs Tab

First Chromatograph Archive

Default = 751.

Collect Chromatograph 1

Default = Not Selected. Select to configure.

Chromatograph 1

Click to select or create the Meter Object assigned to Chromatograph 1. See the Meter section for more details.

Chromatograph 1 Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

Collect Chromatograph 2

Default = Not Selected. Select to configure.

Chromatograph 2

Click to select or create the Meter Object assigned to Chromatograph 2. See the Meter section for more details.

Chromatograph 2 Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

ChroMODograph Tab

TGP ChroMODograph

Default = Not selected. Select if this device is a TGP ChroMODograph.

Cold start latch bit

Default = 1621. Cold start latch bit address.

Skew

Default = 0. Skew factor.

Allow writes

Default = Not selected. Select to allow writes to cold start latch bit and time sync.