Meter Runs Tab

Meter Run Settings

Select the meter run for which to configure the following settings:

Meter

Click to select or create the Meter Object assigned to the selected meter run. See the Meter section for more details. Assigning a Meter Configuration to the Meter is required. Only BSAP signal and analog array items may be used as addresses in the Meter Configuration object.

GC Write Config

Click to select or create the Gas Chromatograph assigned to the selected meter run. See the Gas Chromatograph section for more details.

Configuration Item Token Number

Default = Number of meter run. Allows multiple meters to share a single Meter Configuration or Gas Chromatograph object, as long as the meters use the same item names for these objects apart from the run number. Items in the shared Meter Configuration and Gas Chromatograph objects will use a token instead of the run number:

? - replaced by the token number: 1, 32, 255
?? - replaced by the token number padded out with zeroes to at least two digits: 01, 32, 255
??? - replaced by the token number padded out with zeroes to at least three digits: 001, 032, 255

For example, FC.FC1.RX_TAP_LOC, FC.FC2.RX_TAP_LOC, etc. would be entered as FC.FC?.RX_TAP_LOC.

When each meter accesses the shared Meter Configuration or Gas Chromatograph object, the tokens in the item names in that object will be replaced by the value of this field for that meter.

For example, if the token number of the meter run is set to 4, FC.FC?.RX_TAP_LOC will be polled as FC.FC4.RX_TAP_LOC for that meter.

Collect Daily/Hourly/Minute

Default = Not selected. Select to collect and configure access and archive objects used in collection.

Daily/Hourly/Minute Access

Click to select or create the Daily/Hourly/Minute Access object. See the BSAP Archive Access section for more details.

Daily/Hourly/Minute Archive

Click to select or create a Configurable Archive. See the Configurable Archive section for more details.

Collect User Upload