See the Common Device Configuration guide for assistance configuring the General, Options, Details, and Logging tabs. See the Connection/Schedule page for assistance with the Connection tab. |
See the Common Modbus Configuration (Device Tab) page.
Default = Not selected. Enable this to configure and allow requests to be made.
Click to select or create the Connection Object assigned to this device. See the Time Synchronization section for more details.
Select the desired Time Synchronization Interval relating to the Schedule object assigned on the Connection tab. Time Synchronization checks occur on the frequency of this interval.
Default = UTC-06:00 Central Time (US & Canada).
Default = 40101.
Default = 40106.
Default = 40093.
Default = 40094.
Default = 40095.
Default = 40096.
Default = 40097.
Default = 40098.
Select the desired Daily Interval relating to the Schedule object assigned on the Connection tab.
Default = 0.
Default = 40099.
Default = 40107.
Default = 5.
Default = Not Selected.
Meter Object assigned. Click to select or create one. See the Meter section for more details.
Click to select or create a Configurable Archive. See the Configurable Archive section for more details.
Default = 40108 - 40252.
Default = 40123 - 40267.
Click to select or create the GC object that is configured with IO addresses for gas component data. See the Gas Chromatograph section for more details.
Click to select or create the GC object that is configured with IO addresses for gas component data. See the Gas Chromatograph section for more details.
Default = 22. Address used to inform device that GC data has been written.
Default = 15. Address used by device to signal GC write success/failure.
Default = 0. Delay (in ms) between staging GC write and checking status.