Overview
Eagle Advance The following information is to assist when establishing "Rules" in the Eagle Advanced Meter Configuration “Rule” setup. The same Rule may be found in device setup with Talon Software (Eagle Research).
See Meter Configuration for details.
Enter the Address with correct PPSSII and scaling if available.
...
- If the value of the address along anded with 0x0600 is equal to 0, then this is a NX19.
- If the value of the address along anded with 0x0600 is equal to 0x0200, then this is AGA8_Gross1.
- If the value of the address along anded with 0x0600 is equal to 0x0400, then this is AGA8_Gross2.
- If none of the above applies, this is an AGA8_Detail.
...
- If the value of the address along anded with 0x1E is equal to 0, then this is PSI.
- If the value of the address along anded with 0x1E is equal to 2, then this is Kilopascal.
...
- If the value of the address along anded with 0x01 is equal to 0, then this is a F.
- If the value of the address along anded with 0x01 is equal to 2, then this is a C.
...
- If the value of the address along anded with 0x01 is equal to 0, then this is BTU PER FT3.
- If the value of the address along anded with 0x01 is equal to 2, then this is MJ_PER_M3.
...