Modbus Block History Configuration
- Michael Standal
- Emma Fullilove (Deactivated)
- kristina schaeffer (Unlicensed)
Device Tab
See the Common Modbus Device Tab page.
Time Sync Tab
Enable Time Synchronization Through Timezone
See Common Time Sync Tab for general Time Sync configuration details.
Device Time Read Start Address
Default = 40101.
Device Time Read End Address
Default = 40106.
Device Time Write Year Address
Default = 40093.
Device Time Write Month Address
Default = 40094.
Device Time Write Day Address
Default = 40095.
Device Time Write Hour Address
Default = 40096.
Device Time Write Minute Address
Default = 40097.
Device Time Write Second Address
Default = 40098.
Archive Collection Tab
Daily Collection Priority
- Low (Default).Queues up with other Low priority items.
- Medium. Interrupts Low priority items, and queues up with other Medium priority items.
- High. Interrupts Medium and Low priority items, and queues up with other High priority items.
Daily Collection Interval
Select the desired Daily Interval relating to the Schedule object assigned on the Connection tab.
Contract Hour
Default = 0.
Day Request Address
Default = 40099.
Day Loaded Address
Default = 40107.
Record Load Timeout
Default = 5.
Meter Runs Tab
Meter Run Settings 1-10
Enable
Default = Not Selected.
Meter
Meter Object assigned. Click 
to select or create one. See the Meter section for more details.
Daily History Archive
Click to select or create a Configurable Archive. See the Configurable Archive section for more details.
Daily History Start Address
Default = 40108 - 40252.
Daily History End Address
Default = 40123 - 40267.
Gas Chromatograph Tab
GC Read Config
Click to select or create the GC object that is configured with IO addresses for gas component data. See the Gas Chromatograph section for more details.
GC Write Config
Click to select or create the GC object that is configured with IO addresses for gas component data. See the Gas Chromatograph section for more details.
GC Write Staged Address
Default = 22. Address used to inform device that GC data has been written.
GC Write Status Address
Default = 15. Address used by device to signal GC write success/failure.
GC Write Status Check Delay
Default = 0. Delay (in ms) between staging GC write and checking status.
For assistance, please submit a ticket via our Support Portal, email autosol.support@autosoln.com or call 281.286.6017 to speak to a support team member.