Overview

The TCP Pool connection allows ACM to use multiple modems on TCP/IP terminal servers (or similar devices) through the configuration of a single port. ACM then can use any available modem in the pool to poll devices. This reduces waiting time for access to modems because any available modem can be used for polling. To connect to a device that supports TCP Pool, the host computer must have Ethernet network connectivity.

The TCP Pool Connection release connections between poll intervals.

Configuration

Once a port has been added to the ACM server, the port must be configured by editing the created object. Configuration may be accomplished using the default Form view.

See the General Object Configuration guide for assistance configuring the General tab. See the Common Port Configuration guide for assistance configuring the Options tab.

Port Tab

Connection Type

The type of connection to establish with the remote address.

TCP (default)
UDP
- Select UDP Receive Port Default = not selected. Select to use a specific UDP port instead of allowing Windows to select the port.
- UDP Receive Port Default = 0. The local port to use for receiving UDP communications.

Port Control

The method used to determine exclusive control of the connection.

Maintain Control (Default)
Release When Done

Port Release Delay

The length of time in milliseconds to keep control of the port after communication is done. Used in conjunction with Port Control = Release When Done.

Lost Connection Timeout

The maximum length of time in seconds to allow to pass with no incoming data before closing the port and reestablishing the connection.

Enable Dialup Modem

Use a modem when communication through this port.

Modem Test Interval

The interval in minutes at which a command is sent to a modem to check its status. This only applies when the Port Control is set to "Maintain Control"

Info

Use "0" to disable the status check.

Port Options

Lazy Connection. Select to prevent ACM from attempting to re-establish the connection before the next poll.

Host Addresses Tab 1-3:

To configure Host Address 01-48:

Enter the appropriate Host/IP address and Port using the format xxx.xxx.xxx.xxx:nnn or name.doman.com:nnn
Select Port Use.
- Disabled (Default)
- Polling
- Call-In Only

Commands

See Object Commands for how to locate and execute a command.

Command	Description	Parameters
Clear Modem Status	Set all modem status flags to 'good'	None

Browser not supported