See the Common Device Configuration guide for assistance configuring the General, Options, Details, and Logging tabs. See the Connection/Schedule page for assistance with the Connection tab. |
Default = PLC-5. Select the processor type in use for this configuration.
Default = 244. Used to control the maximum number of data bytes requested by the PLC. This will be capped by the value entered here, or by the maximum supported by the selected Processor, whichever is lower.
Word Range Read Write
Primary and Secondary Communication Type refers to the final physical connection to the device (Ethernet or Serial). As such, the Serial Settings section only applies if either the Primary or Secondary connection type is set to serial. Otherwise, the Serial Settings section is disabled. |
Default = Serial. Select Serial or Ethernet.
Default = Serial. Select Serial or Ethernet.
Default = 9.
Default = 1.
Default = 0.
The ControlLogix®-Specific Settings are enabled only if ControlLogix® is selected as the processor type. The Processor Slot Number refers to the physical slot in the chassis where the processor resides. This number is zero-based with zero being the default.
The Enhanced Logging option at the bottom outputs additional debug information about each message sent which may be helpful in a support situation.