This object links to a Broker Connection to publish all data collected by Edge ACM in Sparkplug B format.
General
Name
A unique identifier for this object
Enabled
The current Enabled status of this publisher; nothing will be published if it is not enabled
Folder
The parent folder of this object
MQTT
Publish QoS
The Quality of Service for published messages
0 - At most once (least bandwidth, least reliable)
1 - At least once (middle bandwidth, middle reliability)
2 - Once and only once (most bandwidth, most reliable)
Subscribe QoS
The requested Quality of Survice for subscribed messages (typically tag value writes from remote clients)
0 - At most once (least bandwidth, least reliable)
1 - At least once (middle bandwidth, middle reliability)
2 - Once and only once (most bandwidth, most reliable)
Broker Connection
The Broker Connection object used by this Sparkplug B Publisher object
Sparkplug B
Group ID
The Group ID used in the Sparkplug B message, a name that can be shared by multiple devices so that clients can more easily group their published data
Node ID
The identifier used in the Sparkplug B message, it should be unique on the broker to avoid confusion
Primary Host ID
Optional. The Host ID the publisher expects to be receiving data. If a value is provided, the publisher will stop when the expected Host is offline then resume publishing and backfill when the Host comes online
Disable Tag Aliases
When Tag Aliases are disabled, the full tag name will be sent with each update of tag values. This can be useful for clients that missed the Birth notice or to manually read data, but requires more bandwidth
Backfill
Backfill to Disk
Enable storing Backfill data on disk instead of in RAM. On most devices this will allow more storage
Disk Location
The location on the Linux system that backfill data will be stored
Disk Memory Allocated for Buffered Values (mb)
The maximum amount of backfill data to be stored on the disk
Split Backfill Messages
Divide up backfill messages rather than sending a single large ddata message
Tag Values per Message
When splitting the backfill message, set the maximum number of tag values sent per message
Advanced Sparkplug
Republish Payload After Disconnect
On QoS 1 or 2 this will force eACM to republish the most recentl sent message if it lost the broker connection without confirmation that the message was received
Serialize Publishing
On QoS 1 or 2 ensures packages are published in sequence and only after the previous message receipt is confirmed
Delay Between Births (s)
The minimum amount of time to wait between rebirth messages, if a rebirth request is issued durring the delay the next birth message will not be sent until after the dealy
Advanced MQTT
Delay Between Publishes (ms)
The time in milliseconds between published messages
Info
Information on the installed version of this object