...
Connection Settings Tab
Poll Cycle Settings
...
Default = Not selected. When all configured Message Retries have been transmitted and no valid response has been received, a message is in a No-Response state. If this occurs, and the option to ‘Abort Poll After First No-Response’ is enabled, then no more request messages will be transmitted for the device during its current poll cycle. Polling for this device will continue the next time its schedule comes due, or if a non-scheduled event occurs (such as a demand poll).
Dialup Modem Tab
Used for the device objects using this connection settings object.
...
The maximum number of tries to issue a modem command with no response before continuing to another poll. Default = 2.
Command Timeout
The maximum amount of time in seconds to wait for the modem to respond. Default = 2
Connect Timeout
Maximum amount of time in seconds to wait for the modems to establish a connection. Default = 35.
...
The modem dial prefix. Use ATDT for tone dialing, ATDP for pulse dialing or another custom setting. Default = ATDT.
Connect String
The string returned by the modem to indicate a connection to a remote modem. Default = CONNECT.
Hangup String
The command string to hang up the modem and terminate the call. Default = ATH0.
...
The initialization string used to configure the modem. Default = ATE0Q0&C1&D2&S1V1X4.
Warmup Delay
The time to wait in milliseconds between connection to the remote modem and sending the first poll message. Used for line stabilization. Default = 0.
Between-Call Delay
The time to wait in seconds between finishing one call and beginning another. Default = 0.
...