...
Primary/Secondary Use BSAP Ethernet
Default = Not selected. Select this option if communicating with a BSAP RTU through its Ethernet port.
Primary/Secondary Use UDP BSAP Connection
Select to indicate that the port will be using a UDP port as its BSAP connection.
Primary/Secondary Use Standard header
Use the standard header instead of the extended IBP header. The standard header does not include the IP address.
Primary/Secondary BSAP Sub Packets
Maximum sub-packets in a IBP packet (1-4).
Time Sync IP Address 1 & 2
The IP addresses on which to monitor the Time Sync port.
Time Sync Port
Port used to receive Time Sync messages from the RTU.
| Info |
|---|
Be certain the firewall allows incoming UDP connections on this port. Time synchronizations using the BSAP Ethernet protocol are handled differently from those of other protocols. For ACM to successfully perform a BSAP Ethernet time sync, follow the configuration directions here. |
Packetizing Delay
After the first sub-packet is ready to send, this is the amount of time in milliseconds the RTU will wait for additional sub-packets before sending the packet.
Alarm IP
The IP address to which the RTU should send alarm notifications.
| Info |
|---|
As ACM does not currently support alarm notifications, it is not recommended to use the ACM Host computers IP address. |
RBE IP
The IP address to which the RTU should send RBE notifications.
| Info |
|---|
As ACM does not currently support RBE notifications, it is not recommended to use the ACM Host computers IP address. |